All FN FAL parts are certified authentic, ready to be remade into a hand-built semi-automatic collector FAL rifles. Some parts, such as the bayonets, are time capsules – new, old–stock recovered from 30+ years of storage. Parts that are not included can be found at aftermarket FAL manufacturers to complete a semi-automatic FAL build.
Customers building complete semi-automatic FALs with these parts kits will need to comply with 922(R) requirements via the use of 8 U.S.-made components for the final build.
WHAT IS IN THE FN FAL PARTS KIT
- Trigger module
- Bolt
- Bolt hold open assembly
- Spring
- Charging handle assembly
- Charging handle clocking pin
- Mag catch
- Mag catch spring
- Mag release pin
- Ejector retaining pin
- Ejector
- Locking shoulder
- Retaining spring (gas regulator)
|
- Gas cylinder plug
- Gas block and front sight
- Gas tube
- Gas regulator sleeve
- Bushing gas cylinder tube
- Handguard
- Handguard cap
- Carry handle assembly
- Top cover
- Bayonet
- Sling
- Sling swivel assembly
|
Federal law prohibits the assembly of a semiautomatic FN FAL rifle using more than 10 imported parts listed under 27 CFR § 478.39. Each FN FAL parts kit contains the following 10 imported parts: bolt, bolt carrier, operating rod, trigger housing, trigger, hammer, disconnector, buttstock, pistol grip, and forearm/handguard. You are solely responsible for complying with all applicable local, state, and federal laws when assembling a semiautomatic FN FAL rifle using an FN FAL parts kit.
Each FN FAL parts kit contains once issued used parts that will show signs of wear and light cosmetic marking, including blemishes and discoloration. Metal parts are free of pitting or fatigue. A skilled gunsmith must inspect and assemble the parts contained in each FN FAL parts kit. Each FN FAL parts kit is sold as-is and FN makes no warranty whatsoever with respect to the FN FAL Parts kit, whether express or implied by law, course of dealing, course of performance, usage of trade, or otherwise.
